User's Manual

34
Operation
Motion Detecting Control Panel (continued)
LOCK
The LOCK feature is designed to prevent activation ofthe garage door opener from remote controls
while still allowing activation from the door control and keyless entry.This feature is useful for added
peace of mind when the home is empty (i.e. vacation).
l
Activate: Pressand hold the LOCK button for 2 seconds.The command LED will flash as
long as the lock feature is activated and your handheld remote control will not operate your
door at this time.
l
Deactivate: Press and hold the LOCK button again for 2 seconds.The command LED will
stop flashing and normal operation will resume.
PROGRAM
Any compatible remote controls,wireless keyless entry, or MyQ
®
accessories can be programmed to the
garage door opener by pressing the Learn button.
Push Bar
LIGHT Button
LOCK Button
Command LED
LEARN Button
Remote Control
Your remote control has been programmed at the factory to operate with your garage door opener.
Older Chamberlain remote controls are NOTcompatible, see page 40 for compatible accessories.
Programming can be done through the door control or the learn button the garage door opener. To
program additional accessories refer to the instructions provided with the accessory or visit
www.chamberlain.com.If your vehicle is equipped with a Homelink
®
, you may require an external
adapter depending on the make, model,and year of your vehicle. Visitwww.homelink.com for additional
information.
TO ADD, REPROGRAM, OR CHANGE A REMOTE CONTROL/KEYLESS ENTRY PIN
USING THE MULTI-FUNCTIONCONTROLPANEL
1. Press the LEARNbutton on the door control to enter Programming Mode.
2. Press the LEARNbutton again, the LED will flash once.
3. Remote Control:
Press the button on the remote control that you wish to operate your garage door.
Keyless Entry:
Enter a 4-digit personal identification number (PIN) of your choice on the keyless entry
keypad. Then pressthe ENTERbutton.
The garage door opener lights will flash (or two clickswill be heard) when the code hasbeen
programmed. Repeatthe stepsfor programming additional remote controls or keyless entrydevices.
The command LED
will flash once.
The command LED will
flash once again.
1
2
OR
PIN
? ? ? ?
4
GHI
5
JKL
7
P
RS
8
TUV
9
WXY
0
QZ
*
#
E
NT
E
R
0 QZ
*
#
ENTER
6
MNO
3