User's Manual

4
Hold the overlock in position tight against the door and drill a 1/4" 7.
hole in the door through the top right hole.
With the overlock still held tight in position, place a rivet through the 8.
hole and secure it using the pop rivet tool.
Drill a second hole in the door through the bottom left hole on the 9.
metal plate. Place a rivet through the hole and secure it using the
pop rivet tool.
Drill the remaining three holes in the overlock device. Place rivets in 10.
each of the three holes and secure using the pop rivet tool.
Drill hole in bottom left
hole and insert rivet.
Drill remaining 3 holes using the
overlock as a guide. Secure with
rivets.
Drill hole in top right
hole and insert rivet.
5
Test the actuator again after installation. Press the tamper switch 11.
(S3) located to the left of the battery case to retract the actuator
arm. The actuator should be in the retracted position after
installation.
Install the battery cover. 12.
Install all screws just
until each one holds.
Tighten down each
screw using a cross-
hatch pattern to prevent
binding of the screws.
Installing an Adapter
The standard overlock device is designed for use with Chateau C-DL-1 and
C-DL2 four bolt door latch door hasps. An adapter has been designed so that
the overlock can be used with the Chateau 4 bolt bezel latch hasp type.
Use the following procedure to install the adapter.
After installing the bezel latch, add the lever and the 1/4” x 3/4” 1.
carriage bolt.
Install battery cover.
Lever