User's Manual

6
Add the cover bracket and the nylon or fl ange nut. Tighten until 2.
fi tted snugly using a 1/4”drive ratchet with extension and a 7/16”
socket.
When installation is complete, the adapter should be positioned as 3.
follows.
Install the overlock device using the previous mounting instructions.4.
Nylon or
Flange Nut
Cover
Bracket
Cover
Bracket
Overlock
3
Slide the overlock toward the hasp until the end of the extended 4.
actuator touches the end of the hasp.
NOTE: The actuator will not be visible from the front as the mounting bracket
covers the actuator.
Using the edge of the mounting 5.
bracket as a guide, mark this
position on the door with the
marking pen.
Slide the overlock away from 6.
the hasp until there is a 1/4"
gap between the hasp and the
actuator. Mark this position using
the marking pen.
NOTE: The overlock device may
need to be shimmed to hold the
device tight against the door. If
spacers are used for shimming,
be sure to use them at all fi ve
rivet points. Not shimming a
door that requires it can severely
damage both the overlock and
the door.
Mark edge of mounting
bracket.
1/4"