User's Manual

33
INPUT LEDS
OPEN INPUT OFF Input inactive
ON Input active
FAST BLINK Input active on other operator
CLOSE INPUT OFF Input inactive
ON Input active
BLINK Input active on other operator
STOP INPUT OFF Input inactive
ON Input active
BLINK Input active on other operator
FIRE DEPT
INPUT
OFF Input inactive
ON Input active
BLINK Input active on other operator
SBC INPUT OFF Input inactive
ON Input active
BLINK Input active on other operator
OPEN SAFETY
INPUT
OFF Input inactive
ON Input active
BLINK Input active on other operator
CLOSE SAFETY
INPUT
OFF Input inactive
ON Input active
BLINK Input active on other operator
STATUS LEDS
INPUT POWER OFF OFF state
ON AC charger or Solar power available
BATT
CHARGING
OFF Not charging
ON Trickle charge
FAST BLINK High current charge
FASTER BLINK Over voltage error
TIMER OFF The timer is disabled
ON The timer is enabled
MEDIUM BLINK The timer is running
FAST BLINK The timer is halted
FASTER BLINK The timer is cancelled
GATE MOVING OFF The gate is stopped
ON The gate is opening or closing
FASTEST BLINK The operator is in E2
BATT LOW OFF No battery error
ON Battery low error
SLOW BLINK Battery dead error
MEDIUM BLINK Battery over current error
FAST BLINK Battery over voltage error
FASTER BLINK Extreme temperature error
FASTEST BLINK Battery disconnected error
ACC PWR OVLD OFF OFF state
ON Accessory overload protector opened
CONTROL BOARD LEDS
TROUBLESHOOTING
CONTROL BOARD LEDS
YELLOW DIAGNOSTIC LED
# BLINKS MEANING CORRECTION
1 BLINK
Low Power Mode (not an error)
2 BLINKS
ID resistor failure Check ID resistor wiring, clear limit
settings and reset limits
3 BLINKS
Exceeded Maximum
Run Timer
Check gate travel, if necessary adjust
force setting
5 BLINKS
RPM (obstruction) Check for obstruction, if necessary
adjust force setting
6 BLINKS
Current (obstruction) Check for obstruction, if necessary
adjust force setting
7 BLINKS
Position failure Check gate travel, clear limit settings
and reset limits
RED DIAGNOSTIC LED
# BLINKS MEANING CORRECTION
2 BLINKS
Current Sense Motor control circuit fault, replace
control board
3 BLINKS
FET Failure Motor control circuit fault, replace
control board
4 BLINKS
RAM Failure Memory failure, replace control board
5 BLINKS
Flash Memory
Failure
Memory failure, replace control board
6 BLINKS
EEPROM Failure Memory failure, replace control board
7 BLINKS
Watchdog Failure Controller failure, replace control board
DIAGNOSTIC CODES LEDS