Installation & Assembly

Calx Outdoor Sconce
Installation Instructions
CERNOGROUP.COM T_949.715.1534 1751 MCGAW AVE, IRVINE, CA 92614 COPYRIGHT 2019 CERNO LLC. ISSUE DATE 9/4/2019
General Product Information
4”
4.5”
Remove the mounting plate from the canopy by
unscrewing the thumb nuts.
Removing Mounting Plate from Canopy
1
1
Attach the mounting plate to the junction box using
the provided 8-32 screws.
Connect the xture to ground according to local
electrical codes.
Pull the line voltage wires through the center hole in
the mounting plate. Use wire nuts to make connections
between the line voltage wires and the driver. Tuck wire
nuts into the junction box.
(OPTIONAL) If 0-10V dimming control is to be used,
connect purple and grey LED driver leads to the leads
from the remote 0-10V dimmer.
Wiring Canopy
2
3
4
,QFOXGHG&ODVV/('
'ULYHU
&RQQHFWWR/LQH
9ROWDJH6RXUFH
$&,QSXW/HDGV
'&2XWSXW/HDGV
*UH\ 3XUSOH
9
'LPPLQJ
/HDGV
&RPSDWLEOH
9'LPPHU
RSWLRQDO
&RQQHFWWR)L[WXUH
,QSXW/HDGV
'LPPLQJ1RWHV
,QSXW9ROWDJH 'LPPLQJ0RGHV
9$& 7ULDF(/9RU9
9$& 9RQO\
9$& 9RQO\
CRITICAL NOTE:
If 0-10V dimming is not being used, the tinned ends of
the purple and grey LED Driver leads should be snipped
o and these leads should be capped individually such
that they remain isolated from one another.
This product is suitable for wet locations.
CAUTION - RISK OF FIRE
This product requires installation by a qualied
electrician. Before installing be sure to read
all instructions and TURN POWER OFF TO THE
JUNCTION BOX
Center location of
junction box
2
3
4
Black
(Hot)
White
(Line)
8-32
screws
0-10V Dimming
Wires (Grey and
Purple)
Ground connection