Cedar Shed Industries Hew to Build Penalized Garden Sheds Cedar Shed's ling of premium grades sheds consists of sheds with standardized wall and door panels that allow for ease of installation end customization of window dad doo placements. There ave three instruction manuals that come with each shed iii: {1} provides the steward distractions-for all odes; (2).
USE OF OUTDOOR RATED WOOD ADHESIVE To add addition structural integrity to your Cedar Shed structure, a good outdoor mated widow dismissive can boded Whine panels and parts dre joined together, This would include the following locations: GARDEN SHEDS Ha or panels (plywood) to joist wall panels toddler structure deadbeat wall panels will panels to wall panels top plates to wall panels gable panels to wall panels roof panels to gable panels roof panels To-top plates gussets to rafters PLEASE NOYES: ZEROS Jois
INSTALLING HEADERS TO WALL PANELS The Blank wills panels come with the'headers reined. Taking 2-8” sowers, attach the headers to the top of édéhof thudded as show below. Please note some models such as the REBEL end PRESLEY, the bottom plate instead of the leader being wholefood, Please refer to the following page for detains.
INSTALLING DOOR FRAMES Fore installing fic door frame for either the Dutch door the solid concordance your sideline, please he sure to reprove the bottom door cleat, This steal can be Misheard dy il is oly used to hold the door frame together during shipping. Af the door fame Tote the desired location snd affix to adjacent panels.
Mounting the Trim to the Horizontal Door Father There are two door trim pieces that an’be used depending on whether the doors robe installed on the Ridge side of the shed or the Gable side. When the doors being installed on the Gable side, ype will ends to use the wide door rim place, While if thereon 1s being installed on the Ridge side handbarrow door trim into be used. Please refer tithe Figure below for details: Wide.
INSTALLATION OF DOOR HARDWARE ON SLIDING DOOR The door handle and hasp are installed as per diagrammed below, The knuckle portion of the hasp will reinstalled on the long door stop. In southeast the siding door being installed on a porch, thi brickie will beatified te thd Wasp thin board.
If you have ordered the 7 ft wall or the Ridge Porch option. The infill walls need to be installed at this point. If not please skip to the “INSTALLING TOP PLATES" step. INSTALLING THE 7 FT WALL OPTION Teakettle infill wall parcels and attach each panel on top of sac wall panel by using 43" gewgaws pap panel. Each infill wall spaniel fill correspond to the siz of panel included in your kit. For example 46 1" in-fill wall panels should Be installed on tap of 46 wall pare.
INSTALLING TOP PLATES The 2x3 top plates are the next items fo reinstalled onto the top of the wall panels. The top plates help to give the side walls more rigidity, The templates orris cross attache corner to give comer stability tithe sheds Estelle the top plate stopover the-cadge wall side fiestas these: pieces of top plate will run outsider cone to outside cone 3% sower locations (space approx. 167 {40.6 om.
INSTALLATION OF GABLE PANELS The pate panels sit on lop of (he'top plates and are Usherette the outside edge.
iff gad slide a hereof panel ito place i Cross Sectional Views = too] pant fir its finished position {birds motivation Hahn audit op plate) cedar shake roof — uae 3:3" sires to scours : TENT tof para 10 gable ls TO HOLD FIRST pit” “4 ROOF PANEL eee S50 data ll on IN PLACE = Fr gore gender | wall still late oN A 1 aif slide opposing tof pared dat place. Affix like v WWW CEDAR SHED, COM sonar: salesmanship com TOLL FREE: 1.808.830.
TABLE 1 SKYLIGHT SHEETS WITH CORRESPONDING ROOF PANELS Shed (Roof panel/ Roof panel Roof panels Roof anal/ Roof panel B28 skylight width skylight With skylight width skylight width Skylight width REQUIRE/ 42 374" IF-021/ [RF-0037 42 3/4" |RF-004/ 24" RE-0067 23 T° rose] Bis} [18a] [E10 591] bxR S12 4x8 8x10 axa Sx16 Brat TABLE 2 PARTS FOR SKYLIGHT OPTION FOAM TAPE BOWL: STRIPS NEOPRENE SHED SIZE lengthwise WASHERS 25 fe [7.6 13.
INSTALLATION OF GUSSETS Bach patrol gussets will be installed at the joints between each paired roof panels. Using 43" screws attach the gussets to the face of the wafers: Sew the diagram below: for details.
INSTALLING ROOF FLASHING AND AFFIXING THE TOP OF THE GABLE WALLS The mitral flashing strips need to the:slid dither each consecutive (Fow) of shingles. This help to prevent any Water from instantiating through the roof at the seams between roof panels.
INSTALLING ROOFING FELT AND THE RIDGE CAPS The soling felt comes ina 127wida doll. First voluminous cil the roofing felt into 47 wide strips and lay them over op of ogre dodge: Strapless goa to affix, iF you have one. I not use the 1” shingle nails to affix the roofing felt. The ridge caps me installed along the top of the roof ridge. Using the 2 shingle nails, affix each ridge cups in place.
INSTALLING 7 FT WALL or RIDGE PORCH OPTION TRIM BOARDS There are three changes in the installation of the trio hoards when the firewall option bias been purchased. k Additional skirting required, Like the:top skiving that is forestalled between the gable and wall babels, there will be an additional pics of top slitting that ends to he installed between the wall panels and the n=l panels. See Fig SKY-01 for details. (SKY-01 is shown oi “INSTALLING SKIRTING” section. 2. Vertical trim above the door panels.
INSTALLATION OF VERTICAL TRIM vertical rin.
INSTALLING SKIRTING (TOF) a {rabbis panel wn Bevel siding Carefully pry the. bevel piece at the bootlace of the Fei wall particle above (pother gable or infill wall panel). 3 De pst use 169 much forge ns this Gould caste ¢ the bevel siding arboreal. See Pig S KT-0L for details re Walk anal Fig Sr Fran Gable angel . Rabin p Fig, SKY-02 “ Now slide the skirting place withers pried bevel piece as shiver in Flg SKY-02.
Cars hilly, pry the bevel piece at the bottom sft wall peel, Tho not use too meh gored ay this could cause fhe bevel diving to'break. See Fig. SKI-01 for'details: wall Panel INSTALLING SKIRTING (BOTTOM) 4 Bevel siding Figs SKI-01 Wand Wall Panel Now slide the siding piece under the pried bevel piece 43 shown in Fig SKI-02. SHAG sn Pig: SKB:02 ra Wall Panel Using 6-1 3/4" finishing nails, affix the skirting piece into place gs por Big SKRB0L Nil =a Fig.
MOUNTING OF DOOR HARDWARE AND DOORS Espadrille the holes before mounting the hinges, handles; barre] bolts and hips sing § 167 dill bit, Adolfo 1873.2 mini) gap abide fo, tw sides, aid between the double doors nid the two halves bf the Dutch door, These gaps will allow the dos to swing Freely fare they have been installed. A. Double Door The: double doors some with the hinges ready attached to the doors.
Now affix the door stops: The door stopweomebrdled with two vertical pieces, one horizontal piece, bail end genie piece. Ths center road stop is tie wide please: Working From the interior and keeping tie doors closed, affix the horizontal door stop on to the top door frame first using the 6-1 %™ finishing nails. The wile face of the door stop will bé placed dining the dod frame.
Solid Cedar Door Threshold cedar door Studentship ih such away their the door can remounted 10 spent oriole right. The T-hinge's attached to the face of the dost, The:door Gan bie turned around so the Hinges can be-attached tithe left.or right door frame thus giving you the desired door swing.
dd Af 4 Installations two barrel bolts Used the key the lied dun Window in the closed position asd the Handle, Refer 6 Fie WEDS for details, 5 Window i fly opened Horseshoe Lo a pre _ Za ADL the Darters Tass on Each side at the being of ihe rawhide frame Affix handle to Bottom of slide dow window FIGURE D-3 Window hardware installation details WWW.