Use and Care Manual

NG
LP
NG
LP
FAN
HOT
NG
LP
NG
LP
Figure 12 - Assembling Base Feet
Figure 13 - Attaching Base Feet to Heater
Figure 14 - Securing Heater to Floor
Foot
Columns
Leg
Bracket
Base Cut Out
Screw
Hole
Screw
Screw
Finished
Assembly
UBD30T-160-C BASE STAND FEET
5. Position the heater to the desired location.
Secure the base feet to the oor by using
two Phillips head self tapping screws
(provided) (see Figure 14).
1. Snap the left and right foot columns to-
gether (see Figure 12).
2. Place the column assembly in the center
of the base cut out. Fasten column assem-
bly by using two Phillips head self taping
screws (provided) (see Figure 12).
3. Place leg bracket on the top of column as-
sembly and fasten it by using two Phillips
head self tapping screws (provided) (see
Figure 12).
4. Align four screw holes to the base of
the heater and attach it by using Phillips
head self tapping screws (provided) (see
Figure 13).
INSTALLING BASE FEET