042b60a.book Page 1 Friday, January 17, 2003 2:43 PM @6881042B60@ 6881042B60-A Models T5600, T5620, T5700, T5710, T5720 021024a.
1042b60a.
1042b60a.book Page 1 Friday, January 17, 2003 2:43 PM Congratulations on your purchase of a Motorola product! Product registration is an important step. Registering helps us facilitate warranty service and permits us to contact you should your Motorola product require an update or other service. To register your product on-line, visit www.motorola.com/warranty/radios. Please retain your original dated sales receipt for your records.
1042b60a.book Page 2 Friday, January 17, 2003 2:43 PM Contents Contents 2 Introduction . . . . . . . . . . . . . . . . . . . . . 1 Safety and General Information . . . . 3 FCC Licensing Information . . . . . . . 11 Control Buttons - Models T5600, T5700 . . . . . . . . . . . . . . . . . . . . . . . . 12 Control Buttons - Models T5620, T5710, T5720 . . . . . . . . . . . . . . . . . 13 Getting Started . . . . . . . . . . . . . . . . . 14 Installing the AA Batteries . . . . . . . . . . .
1042b60a.book Page 3 Friday, January 17, 2003 2:43 PM Important Information on Safe and Efficient Operation Read This Information Before Using Your Radio The information provided in this document supersedes the general safety information contained in user guides published prior to July 2000. Transmit and Receive Procedure Your two-way radio contains a transmitter and a receiver.
1042b60a.book Page 4 Friday, January 17, 2003 2:43 PM Safety and General Information • 4 American National Standards Institute (ANSI)/Institute of Electrical and Electronic Engineers (IEEE) C95. 1-1992 • Institute of Electrical and Electronic Engineers (IEEE) C95.1-1999 Edition • International Commission on Non-Ionizing Radiation Protection (ICNIRP) 1998 • Ministry of Health (Canada) Safety Code 6.
Two-Way Radio Operation When using your radio as a traditional two-way radio, hold the radio in a vertical position with the microphone one to two inches (2.5 to 5 cm) away from the lips. Body-Worn Operation To maintain compliance with FCC/Health Canada RF exposure guidelines, if you wear a radio on your body when transmitting, always place the radio in a Motorola-supplied or approved clip, holder, holster, case, or body harness for this product.
Safety and General Information 1042b60a.book Page 6 Friday, January 17, 2003 2:43 PM 6 Facilities To avoid electromagnetic interference and/or compatibility conflicts, turn off your radio in any facility where posted notices instruct you to do so. Hospitals or health care facilities may be using equipment that is sensitive to external RF energy. Aircraft When instructed to do so, turn off your radio when on board an aircraft.
Medical Devices - Hearing Aids Some digital wireless radios may interfere with some hearing aids. In the event of such interference, you may want to consult your hearing aid manufacturer to discuss alternatives. Other Medical Devices If you use any other personal medical device, consult the manufacturer of your device to determine if it is adequately shielded from RF energy. Your physician may be able to assist you in obtaining this information.
Safety and General Information 1042b60a.book Page 8 Friday, January 17, 2003 2:43 PM 8 Potentially Explosive Atmospheres Turn off your radio prior to entering any area with a potentially explosive atmosphere, unless it is a radio type especially qualified for use in such areas as “Intrinsically Safe.” Do not remove, install, or charge batteries in such areas. Sparks in a potentially explosive atmosphere can cause an explosion or fire resulting in bodily injury or even death.
Batteries All batteries can cause property damage and/or bodily injury such as burns if a conductive material such as jewelry, keys, or beaded chains touch exposed terminals. The conductive material may complete an electrical circuit (short circuit) and become quite hot. Exercise care in handling any charged battery, particularly when placing it inside a pocket, purse, or other container with metal objects. Battery Charger Safety Instructions Save these Instructions 1.
1042b60a.book Page 10 Friday, January 17, 2003 2:43 PM Safety and General Information 8. 10 9. An extension cord should not be used unless absolutely necessary. Use of an improper extension cord could result in a risk of fire and/or electric shock. If an extension cord must be used, make sure that: • The pins on the plug of the extension cord are the same number, size, and shape as those on the plug of the charger. • The extension cord is properly wired and in good electrical condition.
1042b60a.book Page 11 Friday, January 17, 2003 2:43 PM Your Motorola radio operates on General Mobile Radio Service (GMRS) frequencies and is subject to the Rules and Regulations of the Federal Communications Commission (FCC). The FCC requires that all operators using GMRS frequencies obtain a radio license before operating their equipment. To obtain the FCC forms, please request Forms 605 and 159, which includes all forms and instructions.
1042b60a.book Page 12 Friday, January 17, 2003 2:43 PM Controls Buttons - T5600. T5700 Control Buttons - Models T5600, T5700 Use P to: • Turn radio on/off • Adjust volume LED Indicator Light Use M to: • Talk • Save a setting Use ^ to: • Transmit call tone Accessory Jack Use Q to: • Scan (Model T5700 only) Use [ and ]to: • Scroll through menus Microphone Speaker 12 Use \ to: • Select menu options • Exit the menu (when pressed while in a menu) • Lock and unlock the keypad (when held down and not in a men
1042b60a.book Page 13 Friday, January 17, 2003 2:43 PM Use P to: • Turn radio on/off • Adjust volume LED Indicator Light Use M to: • Talk • Save a setting Use ^ to: • Transmit call tone Use \ to: • Select menu options • Exit the menu (when pressed while in a menu) • Lock and unlock the keypad (when held down and not in a menu) Accessory Jack Use J to: • Scan (Models T5620, T5710 only) Removable Front Cover Use [ and ]to: • Scroll through menus Speaker Microphone Control Buttons - T5620, T5710, T5720
1042b60a.book Page 14 Friday, January 17, 2003 2:43 PM Getting Started Getting Started Installing the AA Batteries Your radio uses 3 AA Alkaline batteries. 1. With the back of the radio facing you, lift the battery latch up to release the battery cover and remove the cover. 2. Insert 3 AA Alkaline batteries as shown on the inside of the battery compartment. 3. Reposition the battery cover and press down to secure.
1042b60a.book Page 15 Friday, January 17, 2003 2:43 PM Battery Meter The battery icon shows the battery charge level, from full d to empty a. When the battery is empty, the radio chirps periodically after releasing M. Note: Remove the batteries before storing your radio for extended periods of time. Batteries corrode over time and may cause permanent damage to your radio.
1042b60a.book Page 16 Friday, January 17, 2003 2:43 PM 5. Plug the AC power supply into the plug on the desk stand. 6. Plug the AC power supply into a standard wall outlet. 7. Slide the radio into one of the charging pockets facing forward. Getting Started To charge the battery pack separately from the radio: 1. Remove the battery pack from the clear plastic bag. Do not disassemble or unwrap the battery pack. 2. Insert the battery pack into the charging pocket.
1042b60a.book Page 17 Friday, January 17, 2003 2:43 PM Removing the Belt Clip 1. Push down on the release tab at the top of the belt clip to release the catch. 2. Pull the belt clip away from the back of the radio. Turning Your Radio On and Off Turn P clockwise to turn the radio on and counterclockwise to turn the radio off. The radio chirps and the display briefly shows all feature icons available on your radio. The display then scrolls through the available channels and Interference Eliminator Codes.
1042b60a.book Page 18 Friday, January 17, 2003 2:43 PM Getting Started Setting a Channel Your radio has 22 channels. Channels 1-7 and 15-22 are 1 watt. Channels 8-14 are 0.5 watt. When the radio is on a 1 watt channel, z displays. When the radio is on a 0.5 watt channel, y displays. 18 1. With the radio on, press \. The current channel flashes. 2. Press ] or [ to set the channel. 3. Press M to save the channel setting.
1042b60a.book Page 19 Friday, January 17, 2003 2:43 PM Channel Frequency Description Channel Frequency Description 1 462.5625 MHz GMRS/FRS 12 467.6625 MHz FRS 2 462.5875 MHz GMRS/FRS 13 467.6875 MHz FRS 3 462.6125 MHz GMRS/FRS 14 467.7125 MHz FRS 4 462.6375 MHz GMRS/FRS 15 462.5500 MHz GMRS 5 462.6625 MHz GMRS/FRS 16 462.5750 MHz GMRS 6 462.6875 MHz GMRS/FRS 17 462.6000 MHz GMRS 7 462.7125 MHz GMRS/FRS 18 462.6250 MHz GMRS 8 467.5625 MHz FRS 19 462.
1042b60a.book Page 20 Friday, January 17, 2003 2:43 PM Talking and Listening Talking and Listening To communicate, all radios in your group must be set to the same channel and Interference Eliminator Code. To talk, press and hold M. Hold the radio 2 to 3 inches away from your mouth when talking. 20 When you finish talking, release M (press to talk, release to listen). Talk Range Your radio is designed to maximize performance and improve transmission range.
1042b60a.book Page 21 Friday, January 17, 2003 2:43 PM Special Features Interference Eliminator Code To set the code for a channel: 1. Press \ until the code starts to flash. 2. Press ] or [ to select the code. 3. Press M to save the code setting. You can set a different code for each channel using this procedure.
1042b60a.book Page 22 Friday, January 17, 2003 2:43 PM Locking the Keypad Special Features To avoid accidentally changing your radio settings, press and hold \ for 3 seconds or until f displays. You can turn the radio on and off, adjust the volume, receive, transmit, send a call tone, and monitor channels. All other functions are locked. To unlock the radio, press and hold \ for 3 seconds or until f is no longer displayed.
1042b60a.book Page 23 Friday, January 17, 2003 2:43 PM Removing Channels from the Scan List (Nuisance Delete Feature) To remove a channel so the radio does not stop on it while scanning, press and hold ] or [ for at least 3 seconds, then release. This temporarily removes the channel from the scan list. To restore the channel, turn the radio off and then back on. Note: You cannot remove the channel your radio was set to when you started the scan (called your home channel).
1042b60a.book Page 24 Friday, January 17, 2003 2:43 PM Alerts Channel Busy Indicator When a channel is busy, the LED flashes twice per second. Setting and Transmitting Call Tones Alerts Your radio can transmit different call tones to other radios in your group so you can alert them that you want to talk. To set a call tone: 1. With the radio on, press \ 3 times. The current call tone setting flashes and E displays. 2. Press ] or [ to change and hear the call tone. 3. Press \ or M to set the new call tone
1042b60a.book Page 25 Friday, January 17, 2003 2:43 PM Transmitting a Talk Confirmation Tone QT Noise Filtering (Models T5700, T5710, T5720 Only) The QT noise filtering feature helps ensure uninterrupted communication with other Motorola T5000 Series radios that have this feature. This feature filters out unwanted transmissions from other radios. It is useful in places where there is heavy radio traffic, such as at an amusement park or ski resort.
1042b60a.book Page 26 Friday, January 17, 2003 2:43 PM Alerts To transmit to a radio that has QT noise filtering turned on: 1. Select the same channel and Interference Eliminator Code as the other radio. 2. Press ^ to send a call tone. This allows your voice to pass through the QT noise filter on the receiving radio. 3. Press M and speak normally. 26 Note: If you skip step 2, the beginning of your message may not be heard on the receiving radio.
1042b60a.book Page 27 Friday, January 17, 2003 2:43 PM Accessories Using Audio Accessories 1. Turn the radio off. Plug the accessory connector into the jack. See page 12 and 13 for the location of the accessory jack on your radio. 2. Turn the radio on. Lower the volume before placing the accessory on your head or in your ear. 3. Press Q or J while rotating P to adjust the volume to a comfortable level. 4. To transmit, press M and speak into the accessory microphone, if any.
1042b60a.book Page 28 Friday, January 17, 2003 2:43 PM 2. Insert the plug of the audio accessory firmly into the accessory jack (see page 13). 3. Turn the radio on. g displays. Accessories 4. Lower the radio volume before placing the accessory on your head or in your ear. 5. To transmit, speak into accessory microphone. There is a short delay between the time you start talking and when the radio transmits. 6. To receive, stop talking. To turn VOX off, press Mor remove the audio accessory.
1042b60a.book Page 29 Friday, January 17, 2003 2:43 PM This product is manufactured under one or more of the following United States patents. 5896277 5894292 5864752 5699006 5742484 D408396 D399821 D387758 D389158 5894592 5893027 5789098 5734975 5861850 D395882 D383745 D389827 D389139 5929825 5926514 5953640 6071640 D413022 D416252 D416893 D433001 Export Law Assurances This product is controlled under the export regulations of the United States of America and Canada.
1042b60a.
1042b60a.book Page 31 Friday, January 17, 2003 2:43 PM • 22 Channels (8 GMRS, 7 GMSR/FRS, 7 FRS) with 38 Interference Eliminator Codes GMRS channels feature increased power for longer range. 14 channels ensure backward compatibility with FRS two-way radios. Eliminator Codes minimize interference from other groups.