Assembly Instruction Item# 600-2X Large Pet Crate End Table
Page 2/6 A Parts List E D F C (A) Top Panel 1 Pc. (B) Bottom Panel 1 Pc. (C) Left Panel 1 Pc. (D) Right Panel 1 Pc. (E) Back Panel 1 Pc. (F) Door 1 Pc.
Page 3/6 x3 RF50003 x6 RF10004 Lef t C Pan els D Rig ht Diagram 1. Pa n els x3 RF50003 x6 RF10004 Step 1. Attach L-Bracket (RF50003) into the pre-drilled holes on the Left Panel (C) and Right Panel (D) by using screws (RF10004) as per Diag. 1. E RF10052 x2 A Diagram 2. Step 2. Attach Back Panel (E) into the Top Panel (A) by using 2 screws (RF10052) as per diagram 2.
Page 4/6 D E RF10004 x3 A C E D RF10004 x3 A Diagram 3. Step 3. Attach Left and Right Panel (C&D) into the pre drilled holes on the Top Panel (A) using 6 screws (RF10004) as per diagram 3.
Page 5/6 Loosen Tighten Tip: 1 - 4 is the adjustment point for the balance of Bottom Panel (B). 2 RF10041 x6 1 3 B 4 E C D A Diagram 4. Step 4. Attach Bottom Panel (B) into the unit by using 6 screws (RF10041) as per diagram 4.
Page 6/6 Tip: Carefully hold the pins to prevent it from bouncing off A D F C B Diagram 5. RF40002 x2 RF40009 x2 RF44013 Step 5. x2 Assemble the Door (F); Place Spring (RF40002), Door Pin (RF40009) and Washer (RF44013) into pre-drilled holes on the Door (F) as per diagram. Align the pin on top of Door (F) to the hole underneath the Top Panel (A), then align the pin in bottom of Door (F) to Bottom Panel (B).
