User Manual

E-99
Useful features
Advanced programmings and registrations
Error code Message Meaning Action
E050 DETAIL memory full Check tracking detail memory full. Finalize and close the check num-
ber currently used.
E051 CHK/TBL No. is occupied Attempt to made use <New Check>
to open a new check using a
number that is already used for an
existing check in check tracking
memory.
Finalize and close the check that is
currently under the number that you
want to use or use a different check
number.
E053 CHK/TBL No. is not opened Attempt made to use <Old Check>
reopen a new check using a number
that is not used for an existing check
in check tracking memory.
Use the correct check number (if
you want to reopen a check that
already exists in check tracking
memory) or use <New Check> to
open a new check.
E075 Negative balance cannot be
nalized
Attempt to nalize a transaction
when balance is less than or equal
to zero.
Register item(s) until the balance
becomes positive amount.
E101 PLU maintenance le full. Press
<#2> to exit
Scanning PLU direct maintenance/
batch maintenance le becomes
full.
Terminate the maintenance.
E103 PLU Code is not exist. Input the
PLU Code
PLU code is not existed in the le. Enter proper PLU code.
E105 PLU le full Scanning PLU le full Modify the designated item.
E106 Item exists in the PLU FILE The designated item has already
existed in the scanning PLU le.
E112 Close the journal platen arm The journal platen arm is opened. Close the journal platen arm.
E114 Close the receipt platen arm The receipt platen arm is opened. Close the receipt platen arm.
E139 Negative balance is not allowed Attempt to register <–> or <CPN>
when the balance becomes nega-
tive.
Enter proper minus/coupon amount.
E146 Arrangement le full Arrangement le is full. Set the arrangement properly.
E200 Insert SD SD is set. Set SD.
E201 Illegal Format Illegally formatted SD Format the SD.
E202 File not found The designated le is not found in
the SD.
Enter proper le name.
E205 File already exist. Can not write, because designated
le has already been in the SD.
Check the operation and retry.