User Manual

Note1: For information about the relationship between setting values and send/receive values, see the “13.3 –64 - 0 - +63

Setting Value Table” in “IV Setting Values and Send/Receive Values” of this document.

Receive Receipt changes the depth of pitch modulation.

7.18 Vibrato Delay (4EH)

Message Format: BnH 4EH vvH

n: MIDI Channel Number

vv: Value (Note1)

Note1: For information about the relationship between setting values and send/receive values, see the “13.3 –64 - 0 - +63

Setting Value Table” in “IV Setting Values and Send/Receive Values” of this document.

Receive Receipt changes the time it takes until note vibrato starts.

7.19 Portamento Control(54H)

Message Format: BnH 54H vvH

n: MIDI Channel Number

vv: Source Key Number

Receive Receipt of this message ﬁrst stores the Source Note Number for the next note. When the next

Note On is received, the portamento eﬀect is applied to the note using this Source Note Number as the

pitch start point and the Note On event key number as the end point. If there already is a note being

sounded by Source Note Number at this time, the new note on is not performed and the portamento

eﬀect is applied to the pitch of the note being sounded. That is to say that legato play is performed.

7.20 High Resolution Velocity Preﬁx (58H)

Message Format: BnH 58H vvH

n: MIDI Channel Number

vv: Value

Transmit When Hi-Reso Velocity MIDI Out of this unit’s MIDI setting is On, sends the lower seven

bits of 14-bit Velocity when a key is pressed or released.

Receive Receipt is handled, in combination with the following Note On/Oﬀ message, as the lower

seven bits of 14-bit Velocity.

For information about the relationship between the Note On/Oﬀ message and High Resolution Ve-

locity Preﬁx message, see ”Instrument Velocity Resolution” at the beginning of part II.

7.21 Reverb Send Level (5BH)

Message Format: BnH 5BH vvH

n: MIDI Channel Number

vv: Value