user manual

USER’S GUIDE ID-12

Day of the week

Current time

(Hour, minutes, seconds)

DATE (month - date)

PM indicator

• A sticker is affixed to the display of this clock when you purchase it. Be sure to remove the sticker before using

the clock.

• Depending on the clock model, the configuration of your clock may differ somewhat from that shown in the

illustration.

GENERAL GUIDE

1 Time Set buttons

Use these buttons to set the current time.

2 SET button

Use this button when setting the current time.

3 RESET button

Press to reset the clock after replacing batteries.

1 cm

PAGE 1
USER’S GUIDE ID-12 • A sticker is affixed to the display of this clock when you purchase it. Be sure to remove the sticker before using the clock. • Depending on the clock model, the configuration of your clock may differ somewhat from that shown in the illustration. PM indicator Current time (Hour, minutes, seconds) DATE (month - date) Day of the week GENERAL GUIDE 1 Time Set buttons Use these buttons to set the current time. 2 SET button Use this button when setting the current time.
PAGE 2
USER’S GUIDE ID-12 SETTING THE TIME BATTERY REPLACEMENT 2) to cycle through the setting screens as shown below. 1. Press the SET button (2 Replace batteries whenever the display of the clock becomes dim and difficult to read. 1. Open the battery compartment cover as shown in the illustration. 2. Remove both old batteries. 3. Load new batteries. Make sure that their positive (+) and negative (–) ends face in the correct directions. If you load batteries incorrectly, they can burst and damage the clock. 4.