Owner's Manual

4
System controls: SYSTEM, UTILITY, FLAT, RTA (These also act as software buttons
when in SYSTEM and UTILITY menus.)
CURSOR controls: UP, DOWN, LEFT, RIGHT
ADJUST controls: UP, DOWN
Rear Panel Connections:
The XD88 X-Drive has 8 XLR inputs and 8 XLR outputs. There are also 8 ¼”
Unbalanced inputs, that with the press of a switch, can be used to connect straight to the
Inserts (Input/Output un-balanced) in one jack. This is not an insert into the DSP, but a
single jack connection to plug into the “insert” of a mixer. The Tip connection is the
INPUT and the Ring connection is the OUTPUT.
There is a XLR Microphone Input for the Real Time Analyzer (RTA). This has Phantom
power for using condenser microphones.
There is a USB type B jack for connection to a PC for remote control using Carvins
XD88 control software.
The power receptical is a standard IEC that will take from 90 – 250 VAC as a power
source. The ground connection on a power cord should never be removed. There is a
Ground Lift switch next to the power jack to help in solving ground loop problems.