Installation & Assembly

TROUBLE SHOOTING AND REPAIR
PUCK WILL NOT FALL THROUGH PUCK TROUGH.
1. Check puck trough channel for dirt and or blockages.
2. Inspect for any binding of the switch wire within the slot. Wire should move freely within the slot. If any binding occurs
bend wire slightly to adjust.
GEAR MECHANISM HARD TO TURN
1. Stripping of gear teeth can cause binding. Although the game is equipped with a slip
clutch, gear tooth damage may occur after numerous game plays. Remove gear
mechanism and inspect teeth for any damage. If gear or clutch are worn out, replace
mechanism.
2. A worn gear housing will cause binding or sloppy action. If this occurs, replace
mechanism.
GEAR REPLACEMENT
1. Remove the dome and carefully place it next to the game, being careful not to scratch it.
2. Remove all players from the game by firmly pulling up on the player.
3. Carefully lift the play surface from the game.
4. Remove the gear from the rod by unscrewing the gear halves, which connect the gear to the rod.
5. Assembly is the reverse of steps 1-4.
PLAYER TRAVEL
1. Player rubs on edge of slot. Check alignment of guide strip. Adjust if necessary by
repositioning.
2. Check for wear of guide strip or gear mechanism. If so, replace.
3. Check for debris or blockage in guide strip.
ELECTRONIC SCORING
1. If goal is scored and not registered, check the switch wire actuator. When puck passes the
wire a score should occur. If not, bend wire to adjust.
2. If unit does not power up, check batteries.
3. Check connections. In-line cable connector, score switch terminals, and connector inside score housing. Although the unit
was inspected in assembly, loosening of connections may occur during shipping.
GOALIE LOOSE OR TIGHT
1. If goalie does not move when control knob is rotated, tighten screw at end of goalie shaft.
2. If goalie moves less than full travel, check goalie wire position. Refer to assembly instructions. If wire is incorrect,
reposition. NOTE: The drive arm should be pointing up. Over travel also may occur if the slip screw at the end of the goalie
shaft is too tight, or if the drive arm binds with the goalie shaft not allowing slippage. If so, adjust or free binding. NOTE:
If adjustment screw keeps loosening, remove and add a drop of super glue to the end of the screw and reassemble.
TO ENHANCE GAME PLAY
If puck tends to lay in goal area, add a dry film lubricant (silicone) to puck trough surface and both sides of puck. Clean all
surfaces of any dirt prior to application of dry film lubricant. Wipe after applying. NOTE: Liquid lubricants will attract dirt
and impede performance. Wipe clean and check play prior to any lubricant application.
FOR TECHNICAL ASSISTANCE CONCERNING PRODUCT ASSEMBLY, OPERATION, OR REPLACEMENT
PARTS, PLEASE CALL US AT 231-845-1263.
PO BOX 649, 218 E. DOWLAND ST.
LUDINGTON, MI 49431
[phone]
www.carrom.com
SUPER STICK HOCKEY
ASSEMBLY & INSTRUCTION MANUAL
Tools Required: Adjustable Wrench, Phillips Screwdriver
• Automatic game shut off.
• Restart game at any time by
simply depressing start button.
• Player gear mechanism is
equipped with a slip clutch to
avoid damaging the player or
gear assembly during normal
game play.
• The dome rests inside the game
for easy access if service is
necessary.
• High strength solid fiberglass
player rods.
• Solid ¾” thick high strength
composite wood cabinet.
• Solid ¾” thick rubber stop
bumpers and reinforced high
impact “ABS” stop brackets.
PRODUCT REGISTRATION
Visit www.carrom.com to register your product(s) to receive the latest updates, special offers
and other product related information.
CAUTION: This is not a toy and is intended for
use by or under the supervision of ADULTS!
07.415.10 08/14