Instruction manual

29
6b.  Tape breakaway plate in position. At one of the locations
marked in step 6a, drill a 1/8" hole straight down through
it and engine bearer. Insert a #4-40 x 3/4" soc. head
screw through hole.
6c.  Continue this procedure, one hole and screw at a time,
until all four screws are in place.
7.  Remove breakaway from fuse.
8.  Position hatch cover on fuse. Press hold-down against
front of firewall and up against bottom of hatch cover as
shown. "Straight action" end should point towards fuse
bottom. Tape in position.
 Remove hatch cover and apply SUPER JET to hold-
down. Replace hatch on fuse, gluing it to hold-down. Let
dry.
 Secure hold-down to hatch with two #2 x 3/16" screws.
 Set hatch in position on fuse. Mark location as shown
for #2 shoulder screw. Install screw in marked location,
exposing enough unthreaded shank to engage hold-
down. Snap on and off several times.
9.  Carefully remove side windows from vac-formed sheet
by cutting on lines (about 1/4" all around windows).
 Using no glue at this time, temporarily fit windows into
fuse openings. If they fit too tight, causing them to bulge,
remove and lightly sand openings the minimum required
for good fit. Remove windows from fuse and set aside
until later.