Instruction manual

16. When satisfied with the fit, draw match-up

lines on both the stab and the fuse to show the correct

location of the stab on the fuselage.

17. Using a sharp-bladed hobby knife, strip

covering from the stab at the points where the stab and

fuse mate, being sure to leave 1/8" to 3/16" of covering

overlap, as shown above. Erase any marks that will show

after the installation.

18. Mix epoxy as before (about 2 large spoon-

fuls), and glue the stab in place on the fuselage. Check

again to make certain the tail assembly is level and

straight. Allow epoxy to dry THOROUGHLY.

1. Collect the following parts:

(1) Fin/rudder assembly

(1) Small control horn

(2) #2-56 x ½" screws

2. Remove the wing. Add a drop of thin CA

to the fin/rudder hinges, as you have done with the aileron

and elevator hinges. When dry, CHECK TO MAKE SURE

THE HINGES ARE SECURELY GLUED by pulling gently,

but firmly, on the rudder.

3. Making sure your rudder/fin assembly is

facing the same direction as the above photo, measure up

from the bottom of the rudder ½" (12 mm.) Put a mark,

next to the hinge line, for the location of the control horn.

4. Separate the nut plate from the small con-

trol horn.

CAUTION: In the following step, take great care to avoid

cutting into the wood structure underneath the covering!

INSTALLING THE FIN