user manual

ManualsBrandsCarcomm ManualsPDAs & SmartphonesPDA CMPC-41

Mobile PDA CradleMobile PDA Cradle

All used brandnames are owned by their respective owners

Introduction

WARNINGS

This installation manual has been prepared to provide the basic information needed to

install the CMPC-41. This manual is not intended to be definitive, because there are

different models and types of vehicles which will require different installation work.

The information given is for general guidance only.

The terms of warranty demand that this mobile PDA cradle is installed by an experienced

installer. An end-user should never attempt to install this mobile PDA cradle without

professional assistance as the installation requires special tools and knowledge.

Note: Thoroughly read the manual before beginning the installation procedure.

1. Ensure that the vehicle’s battery is disconnected before you start the installation

procedure and that it remains disconnected during the procedure.

2. Do not smoke or use open flames when working near the vehicle’s fuel system.

3. Ensure that the vehicle’s electrical cables, hydraulic lines, fuel lines and safety

equipment are not damaged during the installation.

4. Ensure that normal control and operation of the vehicle is not obstructed by the

installation,particularly the brakes and steering. Ensure that airbag operation is not

obstructed.

5. Electronic and other sophisticated systems (for example speed control, ABS anti-lock

brake,fuel injection-, navigation- and airbag systems) are relatively immune to

malfunction caused by PDA or GPS receiver. However, should you experience false

operation of these systems or are in any doubt whatsoever as to their functionality,

please consult the vehicle’s dealer.

6. The mobile PDA cradle is suitable for use only in vehicles with a 12V negative

grounding. Use on other supply voltages or alternative polarity will damage the

equipment.

7. The PDA should not be left switched on for extended periods without running the

vehicle’s engine. Failure to comply could drain the vehicle’s battery.

Before starting the installation of the mobile PDA cradle please check if the following

contents are present :

- Mobile PDA Cradle

- Rotating Swivel

- Window Mount

- Suction Cup

- Fuse Holder cable with fuse

- Screw sets

- Surface cleaner

- Manual

www.carcomm.nlwww.carcomm.nl

Safety-Mount® pattern

CMPC-41 PalmOne Universal 16 Pins ConnectorCMPC-41 PalmOne Universal 16 Pins Connector

Compatible devices

Palm Zire 71

Palm TungstenC/W

Palm TungstenT/T2/T3

Palm m125 / m130 / m500

Palm m505 / m515 / i705

Summary of content (2 pages)

PAGE 1
Mobile PDA Cradle CMPC-41 PalmOne Universal 16 Pins Connector Introduction This installation manual has been prepared to provide the basic information needed to install the CMPC-41. This manual is not intended to be definitive, because there are different models and types of vehicles which will require different installation work. The information given is for general guidance only. The terms of warranty demand that this mobile PDA cradle is installed by an experienced installer.
PAGE 2
Mobile PDA Cradle CMPC-41 PalmOne Universal 16 Pins Connector Installing the Mobile PDA Cradle 1. Mount the window suction mount or Safety-Mount® (sold seperataly, instructions included with the product ) To mount the window mount please clean the window and place the window mount in your preferred position. Tighten the nut on the base of the mount to make it stick to the window. Place the window mount in a position where it doesn’t interfere with the operation of the vehicle. 2.