User's Manual

Enter – input the user option
Program – enter programming mode / cancel
STANDARD programming
All programming sequences begin with the Personal Identification Number (PIN). There is only
one MPIN which has been factory set at 0 0 0 0.
Message playback mode
The dialer can be compatible to old dialer. User can choose the message playback mode to
option 2. This enables the user to record one 40 seconds.
User can choose this mode to option1 such that the dialer can playback one more message to
the user to let user know which sensor / zone is triggered.
[PWD] + [PROG] + [1]
1 = 9 seconds message + 6*5 seconds messages
2 = 40 seconds message
Default is 2
Password change
[PWD] + [PROG] + [2]
Enter new password -> re-enter new password
Default password = 0000
Record a message
To record a voice message, press
[PWD] + [PROG] + [3] + [d] + [ENTER]
The display will show “rEcord” and a beep is generate which alerts you to begin recording.
After you are finished recording the message, press [ENTER] key, display will show”PLAY”
and play back the message. After playing the message, the display will return to standby
mode.
Messages record, related to [PROG 1]
0 = main message, 9/40sec
1 = zone 1 message, 2=zone 2 message, 3=zone 3 message …., every zone messages can
record up to 5 seconds.
Playback pre-recorded message
[PWD] + [ENTER] + [3] + [d] + [ENTER]