XF300, XF305 Instruction Manual

127
Customization
4
Custom Picture Settings
[HV Detail Bal.]: Adjusts the ratio between horizontal and vertical detail.
Higher values emphasize vertical detail while lower values
emphasize horizontal detail. This setting can be adjusted
from -8 to 8. (Default: 0)
[Limit]: Restricts how much sharpness is applied. This setting
can be adjusted from -50 to 50. (Default: 0)
[Select]: In addition to the sharpness set by [Level], [Select] sets
the sharpness for areas with higher frequencies. Higher
values apply more sharpness to areas with higher
frequencies. Use this for subjects in which normal
sharpening is not effective. This setting is not available
when the resolution is 720P. This setting can be adjusted
from 0 to 15. (Default: 0)
[
Knee Aperture ]: Allows you to set the sharpness of only the areas above
the knee point by adjusting the gain and slope. When
[Gamma] is set to [Cine 1], [Cine 2], [Wide DR] or
[Hlt.Pri.], this setting has no effect on the picture.
[Gain]: Sets the amount of sharpness . This setting can be adjusted from
0 to 9. (Default: 0)
[Slope]: Sets the slope of the sharpness. This setting can be adjusted
from 0 to 3, with 0 having no slope, 1 having a steep slope and 3
having a gradual slope. (Default: 1)
[Level Depend]: Lowers the amount of sharpness applied to dark areas of
the image.
[Level]: Sets the brightness of the dark areas of the image that will be
affected. This setting can be adjusted from 0 to 50. (Default: 0)
[Slope]: Determines the slope of the area between the upper and lower
parts of the gamma curve. This setting can be adjusted from 0 to 3,
with 0 having no slope, 1 having a steep slope and 3 having a gradual
slope. (Default: 0)
[Offset]: Adjusts the sharpness level of dark areas in the image. Setting
higher values will lower the sharpness level. This setting can be
adjusted from 0 to 50. (Default: 0)
Noise Reduction
Reduces the amount of noise that appears in the image. Select
[Automatic] to have the camcorder adjust the noise automatically.
Otherwise, select a level from 1 (lowest level) to 8 (highest level), or select
[Off] to turn the noise reduction off. (Default: [Automatic])
Skin Detail
The camcorder applies a softening filter to areas in the picture with skin
tones to give a more pleasant appearance. By changing these settings,
you can determine what areas will be detected as skin tones. A zebra
pattern will appear over areas on the screen that are detected as having
skin tones.
[Effect Level]: Adjusts the level of the filter. The available options are [Off],
[Low], [Middle] and [High]. (Default: [Off])