Instruction Manual

Preparations

Preparing the Camcorder

NOTES

• You can also activate the wireless controller by setting an assignable

button to [Wireless Controller] (0 117).

Using the Wireless Controller to Operate the Camcorder

When using the wireless controller, point it at the camcorder’s remote

sensor. When the wireless controller's buttons are operated, the

camcorder's tally lamps will illuminate.

NOTES

• When you use the START/STOP button or ZOOM buttons on the

wireless controller, you must press the record enable button

simultaneously with the desired button.

• When the camcorder cannot be operated with the wireless controller,

or when it can only be operated at very close range, replace the battery.

• The wireless controller may not work properly when the remote sensor

is located under strong light sources or direct sunlight.

Using a Tripod

You can mount the camcorder on a tripod but do not use tripods with

mounting screws longer than 5.5 mm (0.2 in.) as this may cause damage

to the camcorder.

Using a Tripod with 3/8" Mounting Screws

To use a tripod with 3/8" mounting screws, first attach the optional TB-1

Tripod Adapter Base to the camcorder and then attach the tripod to the

adapter base.

1 Remove the tripod base from the camcorder.

• Remove the 4 screws and then remove the base.

2 Attach the optional TB-1 Tripod Adapter Base.

• Firmly screw in the 4 screws.

3 Attach the tripod.

• Firmly screw in the tripod screw.

• If a tripod has both a 1/4" screw and 3/8" mounting screw, firmly

screw in both.

COPY