Owner manual

Adjusting the Image

■ Mac OS X

1 Open the Apple Menu and select [System

Preferences].

2 In the [System Preferences] window, click

the [Displays] icon to display the Display

window.

3 Select the [Display] tab and select the res-

olution closest to the maximum output sig-

nal resolution of the computer from the

[Resolutions] list.

4 Close the [System Preferences] window.

AUTO PC

If the image display is shifted or there is flickering of the screen when [Analog PC]

(WUX5000 / WUX4000) or [Analog PC-1] [Analog PC-2] (WX6000 / SX6000) is selected,

press the AUTO PC button to adjust the projector to the optimal condition.

The adjustment results will be stored. If the projector is used again with the same com-

puter, when the input signal is selected the image will be projected automatically under

the same conditions that were previously adjusted.

■ Performing the Auto PC Function

Press the AUTO PC button to perform projector adjustment.

If the projected image was not properly adjusted with the [AUTO PC] function, perform the

following steps.

• From [Input signal select], select an input signal type based on the resolution of the com-

puter. (P94)

• If the adjustment is still insufficient, from [Input signal settings] select [Total dots], [Track-

ing], [Horizontal position], [Vertical position], [Horizontal pixels] and [Vertical pixels] to

make adjustments. (P95 - P98)

• For the signal types supported by the projector, see the table on page 218.

Remote control