WFT-E7(ver.2) for EOS R INSTRUCTION MANUAL

27
Connecting to a Detected Network Manually
 Enter the encryption key (password) specified for the access point.
For details on the specified encryption key, refer to the access
point’s instruction manual.
 The screens displayed in steps 2 to 3 below vary depending on the
authentication and encryption specified for the access point.
 Go to page 29 when the [IP address set.] screen is displayed
instead of the screens for steps 2 to 3.
2
Select a key index.
 The [Key index] screen is displayed
only if WEP encryption is used by the
access point.
 Select the key index number
specified for the access point, then
press <0>.
 Select [OK] and press <0> to go
to the next screen.
3
Enter the encryption key.
 Press <0> to display the virtual
keyboard (p.28), then enter the
encryption key.
 When a connection with the access
point is established, the [IP address
set.] screen (p.29) is displayed.
Entering the Access Point Encryption Key