User manual

9
Introduction
Turn off the camera before attaching the transmitter.
Ensure the camera battery has sufficient charge. If the charge drops below 19%, you
cannot transfer captured images or back them up to external media.
1
Remove the terminal cap from the
camera.
Unscrew the extension system terminal cap to
remove it.
Screw the terminal cap into the terminal cap
receptacle of the transmitter.
2
Move the lever into the release position.
3
Attach the transmitter.
Align the attachment pin with the WFT-E2/E2A
mounting hole on the camera.
Push the terminal firmly into the camera.
Turn the tightening screw until it stops rotating to
attach the transmitter securely.
4
Move the lever into the locked position.
The transmitter is now attached to the camera.
The transmitter will be powered by the camera.
Removal
Turn off the camera.
Push the lever down, into the release position.
Loosen the tightening screw until it spins freely.
Pull the terminal out of the camera.
Attaching to the Camera
Camera terminal cap
COPY