Manual

August 2007
BUYERS LAB
Lab Test Report

Canon imagePROGRAF iPF820
© 2008 Buyers Laboratory Inc. WARNING: This material is copyrighted by Buyers Laboratory Inc. and is the sole property of Buyers Laboratory. Duplication of this proprietary report or excerpts from this report, in any manner,
whether printed or electronic (including, but not limited to, copying, faxing, scanning or use on a fax-back system), is illegal and strictly forbidden without written permission from Buyers Laboratory. Violators will be
prosecuted to the fullest extent of the law. To purchase reprints of any BLI reports or articles, contact BLI at [e-mail]. Buyers Laboratory Inc., 20 Railroad Avenue, Hackensack, NJ 07601, USA.
12 13
seconds, which translates to 30.2 pph. These are the fastest colour print speeds
measured by BLI to date.
BLACK PRINT PRODUCTIVITY VERY GOOD
 To assess black print productivity, the same 12-page Arch D-size DWF docu-
ment was used. This document was printed using the Canon imagePROGRAF
iPF820 driver set for plain paper/monochrome, using three different quality set-
tings—Draft, Default and Highest Quality. In Draft mode, the 12 pages printed
in 7 minutes and 25 seconds, which translates to 97.0 pph. In Default mode,
the document printed in 12 minutes and 44 seconds, which translates to 56.5
pph and in Highest Quality mode, the document printed in 24 minutes and 41
seconds, which translates to 29.2 pph. These are the fastest black print speeds
measured by BLI to date.
 A job stream consisting of 10 24" x 36" monochrome files (a mix of DWF, PDF and
TIFF) was sent to the printer while in a paused state. The files consisted of five
or fewer pages, totalling 19 pages, and were sent using the Default plain paper/
monochrome driver setting. Timing began when the printer was taken out of a
paused mode, and ended when the last page of the job stream completely exited
the device. The job stream was completed in 23 minutes and 13 seconds, which
translates to 49.1 pph and is considered comparable to other devices tested by
BLI.
 The 19-page BLI job stream was sent to the device alternating job media selec-
tion between the two rolls. Timing began when the printer was taken out of a
paused mode and ended when the last page of the job stream completely exited
the device. The job stream was completed in 23 minutes and 49 seconds, which
translates to 47.9 pph and is above average compared to other devices tested by
BLI.
 The additional 36 seconds required to carry out the 9 roll switches in the job
stream alternating roll test versus the job stream conducted on one media roll
equates to an average roll switching delay of only 4 seconds.
SECURITY FEATURES NOT RATED
 An Administrator password can be set to enable SNMP settings and IPP authen-
tication, and restrict TCP/IP Printing, SNMP settings and MAC address access.
Additional configurable options are available in the Device Manager section in the
Web utility as well as on the hard disk drive with a number of security settings
available.
NOT RATED
SECURITY FEATURES
This report has been reproduced with the written permission of Buyers Laboratory Inc. Any duplication of this report, in whole or part, in any form or manner, without the written
permission of Buyers Laboratory, is unlawful and violators will be prosecuted. ©2008 Buyers Laboratory Inc. To purchase reprints, contact BLI at [e-mail].