Manual

Print Media You Can Use
24
2-24
Important
6 Press  or  to select the type of cut sheet, then press Enter.
If the same type of cut sheet named in the message is already loaded, then
just press the Enter button.
The cut sheet starts to feed.
If the printer detects no skew and there is no problem, then the printer enters
the print standby mode.
The table below lists the possible settings for the cut sheet type.
For Dye Ink
For Pigment Ink
z A skew error occurs if the cut sheet is not straight. In this case, repeat the above
procedure from Step 1 to set the cut sheet.
z You must set the correct type of cut sheet. If the set cut sheet does not match the
Cut Sheet Type setting, make the correct setting.
(Æ “Select the Cut Sheet Type”, P.2-26)
z You should remove each sheet output to the output stacker, one at a time.
Cut Sheet Type
Heavy Coated
Media Name Roll Media Type Setting
Plain Paper Plain Paper
Coated Paper Coated Paper
Heavy Coated Paper Heavy Coated
Glossy Paper Glossy Paper
Photo Glossy Paper Photo Glossy
Photo Semi-Glossy Paper Photo Semi-Glos
Glossy Film Glossy Film
Back Print Film Back Print Film
Proofing Paper Proofing Paper
— Special 1 to 5
Media Name Roll Media Type Setting
Heavy Coated Paper Heavy Coated
Photo Glossy Paper Photo Glossy
Photo Semi-Glossy Paper Photo Semi-Glos
Synthetic Paper (Non-Adhesive) Syn. Paper
Synthetic Paper (Adhesive) Adh. Syn. Paper
Back Light Film Back Light Film
Flame-Resistant Cloth Flame-Res.Cloth
— Special 1 to 5