User Manual

33
NOTES
• About the Power Save mode: To save po wer
when the camcorder is powered by a
battery pack, the camcorder will
automatically shut off if left without any
operations for 5 minutes ( 49). To
restore the power, turn the switch
toward MODE and release it, or turn the
switch to and back to ON
again.
• When recording in very loud places
(such as fireworks shows or concerts),
sound may become distorted or it may
not be recorded at the actual levels. This
is not a malfunction.
Using the Viewfinder
When recording in bright places it may
be difficult to use the LCD screen. In
such case, change the brightness of the
LCD screen ( 30) or use the
viewfinder instead. To use the
viewfinder, keep the LCD panel closed*.
Then, hold both sides of the viewfinder
firmly and pull it straight out until it
clicks.
Adjust the viewfinder as necessary with
the dioptric adjustment lever. You can
also change the brightness of the
screen ( 30). Using the bright setting
will shorten the effective usage time of
the battery pack.
* The LCD screen and the viewfinder
can be used simultaneously when the
LCD panel is turned 180 degrees to
face the subject ( 29).
About the Mode Switch and Recording Programs
Set the mode switch to AUTO to let the camcorder
adjust all the settings for you, allowing you to just point
the camcorder and start shooting.
Set the mode switch to P to select one of the recording
programs.
The Special Scene recording programs ( 52) offer a convenient way to
select the optimal settings to match special recording conditions. Conversely,
with flexible recording programs ( 54) you can set the shutter speed or the
aperture you want, or enjoy the flexibility to change other settings.
D122_NTSC_E.book Page 33 Thursday, July 19, 2007 6:43 PM