User Manual

176  Wi-Fi Functions
2 Set up a new connection point.
* To replace the current settings, touch [Edit] instead and then manually change
the settings. To delete the settings, touch [Delete] and then [Yes].
3 Enter the details of the connection.
* If you select [Open], you can select [No Encryption] or [WEP]. If you select
[Shared Key WEP], you will need to specify the WEP index key.
**Enter an encryption key of your choosing. The encryption key must be one of
the following.
- 5 or 10 alphanumeric characters
- 10 or 26 hexadecimal characters (0-9, A-F)
4 Touch [Automatic] to automatically obtain an IP address.
5Touch [No].
• You can touch [Check Current Configuration] to review the network
settings.
6 Save the settings of the connection point.
* After touching [OK], you can review the network settings. Touch [Wi-Fi Setup]
> [Check Current Configuration] > Desired connection point > [Î] or [Í]
> [K] three times when finished.
NOTES
• If you attempt to test the settings and the camcorder is able to send a
Wi-Fi signal, then a message will be displayed indicating that the con-
nection was successfully established even when the camcorder has not
established a connection to the iOS device.
[Wi-Fi] > [Wi-Fi Setup] > [Network Setup] > []
> [Set Up New]*
Enter an SSID (up to 32 characters) and channel of your
choosing > [OK] > Enter the authentication/encryption
method* and, if applicable, the encryption key** > [OK]
[Yes] > [OK]* > [X]