Network Video Recording Software RM Series Administrator’s Manual
130
Configure a Dynamic Layout
(1) [Layout Name]
Enter the name of the dynamic layout.
(2) [Display cameras that]
Specify the display criteria for cameras.
Click a check box to make a set of display criteria available, and then click each criteria list to select the
criteria. You can specify up to five sets of criteria.
The criteria are (from left to right), the property, operator, and status.
RM
-
64/25/9
1
Click [Layouts] > [New Dynamic Layout] to display the [New Dynamic Layout] dialog box.
2
Specify the criteria for the video windows displayed in the dynamic layout.
Property Operator Status
Tags
= (is)
Camera tags
(isn’t)
Status
= (is)
Camera status (such as [Recording], [Idle], or
[Error])
(isn’t)
Event Type
= (is)
(isn’t)
Event Type
(“Motion detection”, “Sensor”, etc.)
Event Priority
= (is)
(is equal or higher than)
(is equal or lower than)
Event Priority
(“Highest”, “High”, “Medium”, “Low”, “Lowest”)
(1)
(3)
(2)
Property Status
Operator