Camera Management Tool User Manual

Detecting/Setting Cameras
2
33
 Date and Time
(1) [Settings Method]
Select the Settings method for the date and time.
(2) [Date], [Time]
Configure the settings as follows in accordance with the [Settings Method] setting.
When [Set manually] is selected
Set the desired date and time.
Set the time in 24-hour format in <hour:minute:second> order.
When [Set manually] is selected and [Synchronize with computer time] is selected
Synchronizes the date and time with the computer that is currently accessing the camera.
[Time Zone] is not selected automatically so set it separately if necessary.
When [Synchronize with NTP server] is selected
Select the Settings method in [Set NTP Server Settings Automatically].
When [Synchronize with NTP broadcast] is selected
Receives NTP broadcasts sent from the NTP server and synchronizes the time with them.
The camera’s NTP broadcast mode does not support IPv6.
(3) [Set NTP Server Settings Automatically]
[Disable]
Enter the IP address or host name of the NTP server in [NTP Server].
[Use DHCP]
The address of NTP server is automatically acquired from the DHCP server (IPv4).
To configure the settings, you need to set [Network] > [IPv4 Address Settings Method] to [Auto (DHCP)] (P. 30).
[Use DHCPv6]
The address of NTP server is automatically acquired from the DHCPv6 server. To enable this setting, settings for
[IPv6] need to be configured on the camera Settings page. For details about the Settings page, refer to the
camera’s “Operation Guide”.
[Use DHCP/DHCPv6]
The address of DHCP server (IPv4) or DHCPv6 server is automatically acquired.
(1)
(2)
(3)
(4)
(5)
(6)