User Manual

Replace the staple cartridge of the saddle stitch unit

(Staple P1)

Introduction

When a staple cartridge of the saddle stitch unit of the optional Saddle Finisher is almost empty,

the control panel will display a message indicating which staple cartridge must be replaced. The

procedure below describes how to replace the staple cartridge.

NOTE

This procedure is only necessary when the Saddle Finisher is attached.

Required staples

Staple P1

NOTE

You can order all required supplies at your local authorised dealer.

Replace the staple cartridge of the saddle stitch unit

Step Action Illustration

1 Open the front door of the stacker/stapler.

2 Pull out the saddle stitch unit.

3 Grab the tab of the staple case and pull

the staple case out of the staple unit.

4 Hold the cover of the staple case by its

left and right sides

Lift the cover and slide the cover off.

Replace the staple cartridge of the saddle stitch unit (Staple P1)

Chapter 3 - Use the stacker/stapler

Canon Finisher-AK1/Saddle Finisher-AK2/Puncher Unit-BT1/BU1