Setup guide

2
Erasing Shadows and Frame Lines from Copies (Frame Erase)
2-29
Useful Copy Functions
4 Select the desired original frame erase width using “-” or “+,” and
press “OK” press “Done.”
When entering values in millimeters, you can use - (numeric keys) and (Clear).
Even when you enter the values with - (numeric keys), you can change the values
with “–” or “+.”
The value set here is specified for all sides around the original. To set independent frame
erase width values for the top, bottom, left, and right sides of the original, press “Adjust
Each Dim.”
When you select “Adjust Each Dim.,” select the side of the frame erase width using “-” or
“+,” and press “OK”  press “Done.”
The specified mode is set and the display returns to the Basic Features screen.
If you enter a value outside the setting range, a message prompting you to enter the
appropriate value appears in the screen.
NOTE
• If you want to enter values in millimeters, press “mm.”
• The default setting is 1/8" (4mm).