User Guide

4-83
SmartBase MPC600F/MPC400 Chapter 4: Maintenance & Service
Figure 4-39 Service Error Tx Report
a-3) Service activity report (sending/receiving)
NOTE
Header : OK, NG messages
TX/RX NO : Indicates four digits of the transaction number
CONNECTION TEL : Number sent from the other party or number dialled (lower 20 digits)
(OTHER PARTY)
SUBADDRESS : Subaddress number sent from the other party
CONNECTION ID : ID sent from the other party, if the other party is a Canon fax
START TIME : Communication start date and time (on 24-hour display)
USAGE TIME : Communication time (in minutes and seconds)
PAGES : Number of pages for which transmission was complete
(For details, see User’s manual )
RESULT : “NG” display with number of pages for which transmission was
fault, and service error code
MAKER CODE : Maker code
[1000 1000] Indicates a Canon fax
lower nibble
upper nibble
RCV V.8 FRAME : Received V.8 protocol signal
SYMBOL RATE : Symbol rate used for the primary channel
TX LVL REDUCTION : 0 (Fixed)
ERR ABCODE : Code output by the modem when an error occurred (Not used in the field)
ERR SECTXB : Transmit status of the modem when an error occurred (Not used in the
field)
ERR SECRXB : Received status of the modem when an error occurred (Not used in the
field)
RX/TX : Received/transmitted protocol signal
bit 1 to bit 96 of received/transmitted DIS, DCS, or DTS
The V.8/V.34-related items (RCV V.8 FRAME to ERR SECRXB) are not printed on the
Notmal G3 Service Activity Report.