Setup guide

6-27
Chapter 6 Operating Procedures
Back side Brightness/contrast
This is enabled when you scan both sides of a document
and should be used when the document has front and back
sides of different density. Select [Use back side brightness
(contrast)] to change the settings for the brightness and
contrast of the front and back sides of the document.
Front side (Back side) color drop-out
The color drop-out function has a “drop-out” effect that
leaves out a specified color (red, blue, or green) while
scanning, and a “color enhancement” effect that
emphasizes a specified color. You can set each of these
effects for the front side and back side.
IMPORTANT
The color drop-out settings are disabled when the scanning
mode is set to [Color].
❏ File Formats
You can select from the three available file formats TIFF,
JPEG, and PDF, and the modes available for scanning
vary, depending on the file format setting. (See “Mode” on
p. 6-24.)
TIFF format
Select [Single page] to save each page as a separate image
file, or [Multi page] to save one image file containing
multiple pages when scanning multiple pages.
JPEG format
Select the compression rate for JPEG compression.