S530D User's Guide

Starting the Memory Card Utility
74
Using the Memory Card Utility (Macintosh)
Starting the Memory Card Utility
Use the Memory Card Utility to change the settings when you insert a memory card or to
change the mode of the card slot.
Normally, the Memory Card Utility starts automatically when you insert a memory card. To
start the Memory Card Utility manually, follow the procedure below.
Note
➤
• Before you eject a memory card, be sure to discard the " " icon into the
Trash. If you eject a memory card while the access lamp is on or blinking,
the memory card may not operate properly.
• When you select Change the drive’s read/write attribute. and set the
Read/write mode, note the following points:
- Change the write protection (switch or seal to prevent accidental
erasing) of the memory card to write-enabled mode before inserting the
memory card. If you insert a write-protected card, the computer may not
operate normally.
- If you change the contents of a memory card, you must format the
memory card with a digital camera, otherwise you may not be able to
take photographs. This printer supports only the format used by the
digital camera. Since this printer does not support the unique format of
the computer, format it with the digital camera.
- If you change or manipulate the contents of a memory card from a
computer, be sure to print the contents from the computer. If you print
the contents from the operation panel, the information may not print
properly.