NMPJ Ver. 1.2 User's Manual

31
Using the Projector in Direct Mode
Operation in Each Mode
(7) IP address
To connect to projectors in another subnet, enter the projector’s IP address
here and click (8).
(8) Find projectors
Find the projector with the IP address entered in (7). Results of projector
searching are shown in (9).
(9) Projector information
Shows the projector name, notes, IP address, and wireless mark (in case of
wireless LAN connection) for the projector selected in the list or found after
searching by IP address.
(10) Password
Passwords for projectors on which [NMPJ Password] on the projector’s
settings screen has been configured must be entered here before projection.
For details on NMPJ passwords, refer to the projector user’s manual.
(11) Start
Start projection by the selected projector. During projection, this button is
labeled [Stop projecting] and can be clicked to stop projection.
(12) Switch primary/secondary monitor
A number is shown here only when secondary monitor connectivity is activated
on the computer. Clicking the number will switch between the primary and
secondary monitor.
(13) Blank the projector
Pause projection. Click again to resume projection.
(14) Settings
Display the settings window. (P69)
(15) Projection status
Indicates the projection status.