MULTIMEDIA PROJECTOR WUX500 User's Manual

18
Before Installation
Precautions When Carrying/Shipping the
Projector
Precautions for Installation
Be sure to read “Safety Instructions” and “For Safe Use” (P5 – P17). Also
take the following precautions during installation.
■ Do Not Use in the Following Environments
• Locations with excessive humidity, dust, oily smoke or tobacco smoke
Adhesion to the lens, mirrors or other optical parts may reduce image quality.
• Near high-voltage power lines or sources of electrical power
This may cause malfunction.
• On soft surfaces such as carpets or cushioned mats
Heat may build up inside the projector and damage it.
• Locations with excessive temperature or humidity
This may damage the projector. Acceptable ranges for operating and storage
temperature and humidity are as follows.
Prepare the projector as described below before carrying it.
• Disconnect the cables connected to the projector. Carrying the
projector with the cables attached may cause an accident.
• Retract the adjustable feet before moving the projector. Leaving
the feet extended may cause damage.
• Do not strike the projector or
subject it to impact. Doing so may
cause a malfunction.
• Do not install the projector so that it
is inclined or standing vertically. The
projector may be damaged if it tips
over.
• Do not block the air intake or
exhaust vents of the cooling fan.
Blocking the vents may trap heat inside the projector, which
may shorten the useful life of the lamp or damage the projector.
Operating temperature Operating humidity Storage temperature
0°C (32°F) – 40°C (104°F) Up to 85% -10°C (14°F) – 60°C (140°F)
Exhaust vent
Air intake vent