Projector Monitoring Software Ver.1.0.0 User's Manual

21
CHAPTER2•RoutineOperation
Setting the Protocol of a Projector2.5.7
ProjectorsintheProjectorlistwilldisplayas"Disconnected"ifnetworksettingsofprojectors
arechanged.Inthiscase,adjusttheprotocolsettingsoftheprojectorlabelled"disconnected"
in accordance with the changed network settings, with the following procedures.
Select [Protocol settings] from the [Projector] menu.
1
"Protocol settings" dialog will appear.
Select a protocol from the [Protocol] pop-up menu, and adjust the settings.
2
Category Description
IPaddress EnteranIPaddressoftheprojector,in"XXX.XXX.XXX.
XXX" form.
Community name
(SNMP V1/V2c/V3 only)
E n t e r a c o m m u n i t y n a m e w i t h i n 1 5 o n e - b y t e
alphanumerical characters and symbols.
Port number
(LV Series only)
Enter a port number to be used, in one-byte numbers.
Defaultvalueissetto"7142".
Timeout Enter a number of seconds to time out, from 1 to 9.
Password
(SNMP V3 only)
Enter a password within 8 to 15 one-byte alphanumeric
characters and symbols.
* Password is reset if protocol is changed.
Note
An error message will appear and settings will not be registered if a value -
ofanentryisinvalidorinsufcient.Correctitasrequired.
Entries will be cancelled if [X] (Close) or [Cancel] button is clicked before -
clicking the [OK] button.
Projectors may notconnectimmediately afteritsIPaddress is changed. -
Refresh the projector status after a while.
Click[OK]whenyouhavenishedadjustingthesettings.
3
Projector'sprotocolsettingswillbechanged.
COPY