REALiS_SX7_Mark_II_Commands

Projector User Commands
- 217 -
Revision Histor
y
/ Date Chan
g
es Revised b
y
A
pp
roved b
y
RANGE SEL
Input signal setting option request
Format
RANGE□SEL
Response
r:SEL=I, <Setting option 1>, <Setting option 2>, …, <Setting option n>
For details on other responses, refer to the "Error List".
Description
This command is used to inquire about the parameter options which enable the input signals to be set.
(1) For models other than SX7 Mark II: Inquiry can be made when the projector is in both the remote mode
and power-on status at the same time.
For SX7 Mark II: Inquiry can be made whenever the projector is in the power-on status.
(2) A “busy” response is given while the zoom or focus lens is being driven.
(Refer to the ZCONTDRV command and FCONTDRV command.)
(3) It may not be possible to make this inquiry with some input signals.
(4) The input signals can be selected by the SEL command.
Example
> RANGE SEL
< r:SEL=I, AUTO
* Commands are indicated by ">", and responses are indicated by "<".
Commands supported
This defines the environments that support the command (power supply state, input signal state).
SX50
01.00**
SX6
01.01**
SX60
01.01**
X600
01.01**
SX7
01.01**
X700
01.01**
SX7 Mark II
01.02**
O O O O O O O
Environment
This defines the environments that support the command (power supply state, input signal state).
Power Input Mode
Model
OFF ON PM
D-RGB A-RGB1 A-RGB2 COMP Video S-Video D-Video SCART None Remote Local
Remarks
SX50 x O x x x x O O O - - x O x
SX6, SX60,
X600
x O x x x x O O O x x x O x
SX7, X700 x O x x x x O O O x x x O x
SX7 Mark II
x O x x x x O O O x x x O O
* If a state is not supported, "INVALID_MODE", "NOT_POWER_SUPPLIED" or “INVALID_SOURCE” is returned with the Err
response.
* If the necessary signals are not input, 'INVALID_SIGNAL (*****)' or 'NO_SIGNAL' is returned.
* When the power supply state is in the process of switching, an "i:BUSY" reply may be sent.
Reference