REALiS_SX7_Mark_II_Commands

Projector User Commands
- 111 -
Revision Histor
y
/ Date Chan
g
es Revised b
y
A
pp
roved b
y
ZSTEPDRV
Zoom lens step drive control
Format
ZSTEPDRV=<Zoom lens step control parameter:ID>
Parameter
<Zoom lens step control parameter:ID>
WIDE This zooms to the wide-angle end.
TELE This zooms to the telephoto end.
The parameters which can be set at any given point in time can be obtained using the RANGE
command. For details, refer to the RANGE command.
Response
"i:OK" is returned when zooming was completed successfully after step drive.
For details on other responses, refer to the "Error List".
Description
This command is used to drive the zoom lens.
(1) For models other than SX7 Mark II: It can be executed when the projector is in both the remote mode and
power-on status at the same time.
For SX7 Mark II: It can be executed whenever the projector is in the power-on status.
(2) A “busy” response is given while the zoom or focus lens is being driven.
(Refer to the ZCONTDRV command and FCONTDRV command.)
(3) This command functions in the same way as when first the "ZOOM" button on the remote control or main
unit panel is pressed and then the "←" or "→" button is pressed.
(4) The amount by which the lens is zoomed is constant, and it is fixed in the system.
(5) If a zooming error occurs, step drive cannot be controlled.
Example
Control
> ZSTEPDRV=TELE 1-step control is exercised over the zoom toward the TELE end.
< i:OK
Acquisition of parameters which can be set
> RANGE ZSTEPDRV
< r:ZSTEPDRV = I, WIDE, TELE "WIDE" or "TELE" can be set for zoom lens step drive.
* Commands are indicated by ">", and responses are indicated by "<".
Commands supported
This defines the environments that support the command (power supply state, input signal state).
SX50
01.00**
SX6
01.01**
SX60
01.01**
X600
01.01**
SX7
01.01**
X700
01.01**
SX7 Mark II
01.02**
x O O O O O O
* When a command is not supported, "e:0002 INVALID_COMMAND" is returned.
Environment
This defines the environments that support the command (power supply state, input signal state).
Power Input Mode
Model
OFF ON PM
D-RGB A-RGB1 A-RGB2 COMP Video S-Video D-Video SCART None Remote Local
Remarks
SX50 - - - - - - - - - - - - - -
SX6, SX60,
X600
xO x O OO O OOOOO O x
SX7, X700 x O x O O O O OOOOO O x
SX7 Mark II
xO x O OO O OOOOO O O
* If a state is not supported, "INVALID_MODE" or "NOT_POWER_SUPPLIED" is returned with the Err response.
* When the power supply state is in the process of switching, an "i:BUSY" reply may be sent.
Settin
g