Realis Command Codes

Commands

NOSIG Mode Control Setting

Reference

Function Display screen setting when no signal

Parameter

Meaning

BLACK

Black screen

BLUE Blue screen

LOGO User screen

The RANGE command can be used to obtain the parameter range that can be set at that time.

Response

An 'i:OK' is returned after setting is successful.

Description

This sets the display screen when no image signals are input.

(1)

This command is identical to the No signal screen function under the User screen settings in the Display

settings menu.

(2)

Before a user screen (LOGO) is designated, the user image needs to be registered beforehand. (Otherwise, a

“e:1002 NO_LOGO_CAPTURED” is returned.)

(3)

The GET command can be used to obtain the current display screen at no signal.

Example

Setting

> NOSIG=BLUE This sets the “Blue” screen when no signals are input.

< i:Ok

Reference

> GET NOSIG or ?NOSIG

This retrieves the screen when no signals are input.

g:NOSIG=LOGO

Obtain settable parameters

> RANGE NOSIG

< r:NOSIG=I,BLACK,BLUE,LOGO

※Commands are indicated by “>”, and responses are indicated by “<”

Supported Command States

Power supply

Input

Mode

OFF ON PM

D-RGB A-RGB1 A-RGB2 Comp Video S-Video None Remote Local

× ○ ×

○○○○○○ ○○

※If a state is not supported, “INVALID_MODE” or “NOT_POWER_SUPPLIED” is returned with the Err response.

※When the power supply state is in the process of switching, an “i:BUSY” reply may be sent.