Realis Command Codes

Commands

SAT Mode

Control

Setting

Referenc

Function Color saturation setting

Parameter

Setting value (–20 to 20)

Number

The RANGE command can be used to obtain the parameter range that can be set at that time.

Response

An 'i:OK' is returned after setting is successful.

Description

This sets the screen color saturation.

(1)

This command is identical to the Color level function in the Image adj. menu.

(2)

This sets the currently selected input signal and image mode.

(3)

The GET command can be used to retrieve the current color saturation.

Example

Setting

> SAT=–10 This sets the color saturation to –10.

< i:OK

Reference

> GET SAT or ?SAT This retrieves the color saturation.

< g:SAT=1

Obtain settable parameter range (Min, Max)

> RANGE SAT

< r:SAT=N,–20,20

*Commands are indicated by “>”, and responses are indicated by “<”.

Supported Command States

Power supply

Input Mode

OFF ON PM

D-RGB A-RGB1 A-RGB2 Comp Video S-Video None Remote Local

× ○ × ×××○○○ ○○ ×

※If a state is not supported, “INVALID_MODE”, “NOT_POWER_SUPPLIED” or “INVALID_SOURCE” is returned with the Err response.

※If the required signal input is not available, an 'INVALID_SIGNAL (*****)' or 'NO_SIGNAL' is returned.

※When the power supply state is in the process of switching, an “i:BUSY” reply may be sent.