Service Manual

3.8.3 Printing EEPROM data
You can use the following self-print test to check the data recorded in the EEPROM.
Printing EEPROM Data
1) Enter to a service mode. See "Part 3: 3.8 Service Mode" (page 3-21) .
2) Press the RESUME button four times. (The ERROR indicator turns off.)
3) Press the POWER button to print the EEPROM data on completion of the printer
initialization sequence. All EEPROM data is printed in hexadecimal dump format.
3.8.4 Setting destination country
This printer has functions designed for use domestic model BJ F800 and international
model BJC-7100. The destination country flag is set in the EEPROM to select the
relevant function set.
Check that "BJC-7100 Vx.xx Vx.xx x" is displayed at the top left of the test pattern.
When set to the Japanese function set, "BJ F800 Vx.xx Vx.xx x" is displayed.
If the printer has been set for the BJ F800 set, reselect the overseas function set as
follows:
1) Enter to a service mode. See "Part 3: 3.8 Service Mode" (page 3-21) .
2) Press the RESUME button five times. (The ERROR indicator turns on.)
3) Press the POWER button to select the destination setting.
4) Press the POWER button. (If the printer has been set for BJ F800, the ERROR
indicator turns off. If set for BJC-7100, the ERROR indicator turns on. If the
ERROR indicator turns off, skip to 6.)
5) Press the RESUME button once to change the destination setting and to turn the
printer off automatically. (Skip to 7.)
6) Press the POWER button to turn the printer off.
7) Make a test print in service mode to check the destination country setting.
After resetting the EEPROM data or writing data to the EEPROM after it
has been reset, be sure to print and check the data settings.
3-23
BJC-7100
Part 3: Operating Instructions
Total Waste Ink Amount Waste Ink Optimizer Amount Page Count Cleaning Operaion Count
Head Installation/Removal Count
(BC-61 or BC-62e Photo)
Head Installation/Removal Count
(BC-60)
Figure 3-22 EEPROM Data Print (Sample)