Technical information

hp psc 1300 series
chapter 1
6
use your hp psc with a computer
If you installed the HP PSC software on your computer according to the Setup
Poster, you can access all the features of the HP PSC using the HP Director.
This section contains the following topics:
• open the hp director for Windows users on page 6
• open the hp director for Macintosh users on page 8
open the hp director for Windows users
1 Do one of the following to open the HP Director:
– Double-click the HP Director icon on the desktop.
– In the Windows taskbar, click Start, point to Programs or All Programs
(XP), point to Hewlett-Packard, point to HP PSC 1300 Series, then
select HP Photo & Imaging Director.
2 In the Select Device box, click to see a list of installed HP devices
supported by this software.
3 Select HP PSC 1300 Series.
Note: The HP Director graphic below might appear differently on your
computer. The HP Director is customized based on the HP device that is
selected. If your device is not equipped with a particular feature (such as
fax capability), then the icon for that feature will not display in the
HP Director on your computer. Some HP devices might show additional
buttons that are not shown below.
Tip: If the HP Director on your computer does not contain any
icons, an error might have occurred during the software
installation. To correct this, use the Control Panel in Windows to
completely uninstall the HP Director software, and then reinstall
the HP Director.
Light is off. Light is
blinking.
Light is off. There is a problem with
the layout size indicated
on the proof sheet.
• Proof sheet errors also
cause an error
message to appear on
your computer.
1 Verify the appropriate
bubble is filled in on the
proof sheet, and that it
is filled in dark enough.
2 Press the Photo button
next to the memory card
slots to resume printing.
on light
(green)
check
paper
light
check print
cartridge
light
explanation what to do?