User's Manual

6
Power supply Never remove the plug by pulling on the cord.
Pulling on the power cord may damage the cord and cause a fire or electrical shock.
When turning OFF the power, be sure to press [ON/OFF] or unplug the machine.
However, if the machine is unplugged during printing, the FINE Cartridge is not protected
with the cap that prevents the ink from drying. This may affect the print quality of the
machine when printing later.
During electrical storms, turn OFF the power and disconnect the power cord from the
power outlet.
Do not use an extension cord as this may result in fire or electrical shock.
Ensure that the area around the power outlet is kept clear at all times so you can easily
unplug the power cord if necessary. Otherwise you will be unable to disconnect the power
plug in case of an emergency, and it may result in fire or electrical shock.
Never use a power supply source other than the one rated for the machine in the country
where you purchased the machine as it may result in fire or electrical shock.
The operating requirement of this machine is as follows:
100-240 V AC, 50/60 Hz (depending on local electrical requirements)
Do not plug the machine into the same circuit as appliances such as an air conditioner,
television, or copier. These devices generate electrical noise which may interfere with your
machine’s operation.
Whenever you turn OFF the power and unplug the machine, wait at least five seconds
before you plug it in again.
Use only the power cord that came with the machine. Using a different power cord may
cause electric leakage or damage to the machine.
Turn OFF the power and unplug the machine in the following conditions:
z When the power cord or plug is damaged or frayed.
z If liquid has spilled into the machine.
z If the machine has been exposed to rain or water.
z If the machine does not operate normally when you have followed the instructions in the
guides included with your machine.
z If the machine does not operate normally when you have followed the instructions
provided in “Troubleshooting” on page 97.
z If the machine has been dropped or damaged.
z If the machine exhibits a distinct change in performance, indicating a need for servicing.
Turn OFF the power and disconnect the power cord if the machine will not be used for a
long period such as during holidays.
The socket-outlet shall be installed near the equipment and shall be easily accessible.