Operation Manual

Checking the Ink Status with the Ink Lamps
1. Make sure that the power is turned on.
2. Open the scanning unit / cover.
Replacing Procedure
3.
Check the ink lamp.
Close the scanning unit / cover after checking the ink lamp status.
Replacing Procedure
• The ink lamp is on.
The ink tank is correctly installed.
• The ink lamp is flashing.
Flashing slowly (at around 3-second intervals)
Lighting for 3 seconds (A) repeats
The ink is running low. Prepare a new ink tank.
The resulting print quality may not be satisfactory, if printing is continued under this condition.
Flashing fast (at around 1-second intervals)
Lighting for 1 second (B) repeats
- The ink tank is installed in the wrong position.
Or
- The ink has run out.
Make sure that the ink tank is installed in the correct position as indicated by the label on the print
head holder. If the position is correct but the lamp flashes, there has been an error and the printer
cannot print. Check the error message displayed on the touch screen.
An Error Occurs
85