Specifications

Network Setup Troubleshooting
This manual describes troubleshooting tips for problems you may encounter when
setting up.
If you do not nd a description for your trouble here, refer to "Troubleshooting" in the on-screen manual:
Basic Guide/Advanced Guide.
•
Troubles in Setup/Connections
■
5.4 The Another access point with the same SSID exists is displayed during setup P.4
5.5 The New port could not be created i
s displayed during setup P.4
5.6 The Set Printer IP Address s
creen is displayed during setup P.4
5.7 The Enter Password s
creen is displayed during setup P.5
5.8 The You have connected the printer to an unsecured wireless network is
di
splayed during setup P.5
5.9 The
Communication with the Card Slot failed i
s displayed during setup P.5
5.10 The The Card Slot is already mapped as Network Drive to this computer is
di
splayed during setup P.6
5.11 The
Cannot map any more drives, because all the drive letters are assigned is
di
splayed during setup P.6
5.12 The
Timeout error s
creen is displayed during WPS setup P.6
2 Cannot connect to the access point (the access point is not detected)
P.1
2.1 The target access point is not detected P.1
2.2 Cannot connect to the target access point P.1
2.3 Using the machine in a multiple access point setup P.1
3 How to set a network key/network password
P.2
1 Connection checklist
P.1
3.1 About Network Key (Windows)/Network Password (Macintosh) P.2
3.2 How to set a WEP/WPA/WPA2 key P.2
4.1 The machine is not detected P.2
4.2 No machine is detected after the network settings are changed in Windows
P.2
4 Cannot connect to the machine (the machine is not detected)
P.2
5.1 The Access Points screen is displayed during setup P.3
5.2 The An access point could not be detected i
s displayed during setup P.3
5.3 The Printer could not be connected to the specified access point is displayed
du
ring setup P.4
5 The following screen is displayed during setup
P.3
8 Changing the port name
P.6
6 Re-setting the machine
P.6
7 The admin password set to the machine was forgotten
P.6
Restoring the Machine to the Factory Settings
■
Specications
■
1 MX860 series
P.8
1 Initializing using the machine's Operation Panel
P.7