Operation Manual

2. Key Length:
Select either 64bit or 128bit.
3.
Key Format:
Select either ASCII or Hex.
4. Key ID:
Select the Key ID (index) set to the access point.
5.
Authentication:
Select the authentication method to authenticate the printer's access to the access point.
Normally, select Auto. If you want to specify the method manually, select Open System or
Shared Key according to the setting of the access point.
7.
Click OK.
Important
•
If the printer cannot communicate with the computer after the encryption type of the printer was
switched, make sure that encryption types for the computer and the access point match that set to
the printer.
Note
• Changing the network settings with the USB cable temporarily may switch the default printer. In
this case, reset Set as Default Printer.
186