MP970 series Network Setup Guide

9
If “Communication with the Card Slot failed.” is
displayed, click Retry. If it still fails, click Skip to
complete the setup. Then try the network setup of
the Card Slot using the Canon IJ Network Tool.
7 When the Setup Completion dialog box
appears, remove the USB cable, then click
Finish.
The network connection between the machine and
the computer is now successfully established.
To confirm the setup results, click View Setup
Results.
8 When the Setup Complete screen appears,
click Next.
Note
z If “Cannot map any more drives, because all the
drive letters are assigned.” is displayed, click Skip
to complete the setup. After software installation is
complete, remove any drive letter and try the
network setup of the Card Slot again using the
Canon IJ Network Tool. For details, refer to “Using
the Card Slot over a Network” in the User’s Guide
on-screen manual.
z If “The Card Slot is already mapped as Network
Drive to this computer.” is displayed, the Card Slot
is already set up. Click OK, then click Next.
Note
z To change the port name, click View Setup
Results, then click Set Port Name on the
Setup Results dialog box. For details
, refer to
“Changing the Port Name” in “Troubles When Using
the Machine over Network” in “Troubleshooting” of
the User’s Guide on-screen manual.
z If “Unsafe Removal of Device” is displayed, click
OK.