Operation Manual

Advanced Guide
Troubleshooting
Contents
>
Reprinting Photos from Printed Photos
>
Loading the Films
> Loading the Film Strip
C152
Loading the Film Strip
Mount the film strip in the Film Guide stored behind the Document Cover, and then load it on the Platen
Glass. To scan the film strip with a computer, follow the same procedure below.
1. Remove the Film Guide from the FAU (Film Adapter Unit) Protective Sheet.
(1)
Open the Document Cover, and remove the FAU Protective Sheet.
(2)
Turn over the FAU Protective Sheet, then raise slightly the center of the Film
Guide. Pull the Film Guide towards you to remove it, holding it high enough so
that it does not strike the fixing knobs (A).
Important
When printing photos from the film strip, make sure that the FAU Protective Sheet is
removed from the Document Cover. The film strip cannot be scanned if the FAU Protective
Sheet remains attached.
2. Mount the film strip in the Film Guide (B).
(1)
TURN THE SIDE SHOWING THE FILM MARK (C) UP, and open the Film Holder
(D) by pinching the indentations (E) in the directions of the arrows as shown.
Note
Be sure to open the Film Holder so that the hinge parts (F) do not come off the Film Guide.
Page 45 of 1135 pagesLoading the Film Strip