Service manual

5
3. ERROR DISPLAY
Errors are displayed by the LEDs, and ink low warnings are displayed by the Status Monitor.
3-1. Operator Call Error (LED Blinking in Orange)
LED
blinking
Error Corrective action
2 times Paper out Set paper, and press the Resume/Cancel button
to feed the paper.
3 times Paper jam Remove the jammed paper, and press the
Resume/Cancel button.
4 times Ink tank not installed Re-install the ink tanks, and close the front cover.
5 times Print head not installed or failure has
occurred in the print head.
(Non-supported print head (see page 4) is
installed or print head EEPROM data is
abnormal.)
After confirming that the print head is for the
iP2000 (QY6-0054), re-install the print head, and
close the front cover.
If not recovered, with the print head installed,
power the printer off and on.
8 times Waste ink absorber full or platen waste ink
absorber full warning (approx. 95% of the
maximum capacity)
Pressing the Resume/Cancel button will exit the
error, and enable printing.
9 times Non-supported digital camera or digital
video camera is connected.
After removing the cable between the printer and
the camera, press the Resume/Cancel button, and
re-connect the cable. If the error is not resolved,
the connected camera may not be supported for
Camera Direct Printing. Check that a supported
camera is connected.
3-2. Service Call Error (LED Blinking in Orange and Green Alternately)
LED
blinking
Error Corrective Action
2 times Carriage error Turn the printer off and on again. If the error is not resolved,
replace the printer.
3 times LF error Turn the printer off and on again. If the error is not resolved,
replace the printer.
4 times Purge unit error Turn the printer off and on again. If the error is not resolved,
replace the printer.
5 times ASF cam sensor error Turn the printer off and on again. If the error is not resolved,
replace the printer.
6 times Internal temperature error Turn the printer off and on again. If the error is not resolved,
replace the printer.
7 times Waste ink absorber full or
platen waste ink absorber
full
Replace the printer. (In waste ink absorber replacement, perform
the EEPROM information print to identify if the main and/or platen
waste ink absorber should be replaced. After replacement, reset
the applicable waste ink counter(s).)
8 times Print head temperature
rise error
Turn the printer off and on again. If the error is not resolved,
replace the printer.
9 times EEPROM error Turn the printer off and on again. If the error is not resolved,
replace the printer.
13 times PF position error Turn the printer off and on again. If the error is not resolved,
replace the printer.
14 times PF cam sensor error Turn the printer off and on again. If the error is not resolved,
replace the printer.
17 times Motor driver error Turn the printer off and on again. If the error is not resolved,
replace the printer.